TMC5160T Plus (w/o case) – Stepper Motor Driver

BIGTREETECH TMC5160T Plus Stepper Motor Driver

Product Specifications:
Drive Chip: TMC5160-TA
Input Voltage (HVIN): 8V-60V
Maximum Effective Current: 10.6A, Sine Wave Peak Current 15A
Capacitor: 2 x 560uF
Maximum Subdivision: 256
Operating Mode: SPI, SD
Sampling Resistor: 22mΩ

Note:
1.Turn off the power before installing the driver to prevent damage.
2.Do not plug or unplug the driver module with power on to avoid damage.
3.Be cautious of polarity when connecting; reversing can cause the driver to burn out.
4.The factory-installed heat sink should not be removed, as doing so will decrease heat dissipation in the absence of thermal interface material.
5.For large currents (greater than 3A), active cooling is required for normal operation.
6.This product uses a 0.022R sampling resistor, so the maximum effective driving current is 10.6A.
7.Pay attention to the power sequence; ensure the driver power is turned on before the logic power. That is, turn on the driver power first, then power on the motherboard.
8.Regardless of whether the driver uses high or low voltage power delivery, the output voltage from the main control board to the drive must not exceed 24V; exceeding this will damage the driver.